1.1This specification2 covers electric-fusion-welded austenitic chromium-nickel stainless steel pipe suitable for corrosive or high-temperature service, or both, or for general applications.
1.2This specification covers the grades of alloy and stainless steel listed in Table 1. The selection of the proper grade and requirements for heat treatment shall be at the discretion of the purchaser, dependent on the service conditions to be encountered.
1.3Five classes of pipe are covered as follows:
1.3.1Class 1-Pipe shall be double welded by processes employing filler metal in all passes and shall be completely radiographed.
1.3.2Class 2-Pipe shall be double welded by processes employing filler metal in all passes. No radiography is required.
1.3.3Class 3-Pipe shall be single welded by processes employing filler metal in all passes and shall be completely radiographed.
1.3.4Class 4-Same as Class 3 except that the weld pass exposed to the inside pipe surface may be made without the addition of filler metal (see 6.2.2.1 and 6.2.2.2).
1.3.5Class 5-Pipe shall be double welded by processes employing filler metal in all passes and shall be spot radiographed.
1.4Supplementary requirements covering provisions ranging from additional testing to formalized procedures for manufacturing practice are provided. Supplementary Requirements S1 through S6 are included as options to be specified when desired.
1.5The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. The inch-pound units shall apply unless the “M” designation of this specification is specified in the order.