ASTM A1016/A1016M-14e1
$32.00
Standard Specification for General Requirements for Ferritic Alloy Steel, Austenitic Alloy Steel, and Stainless Steel Tubes
1.1This specification covers a group of requirements that, unless otherwise specified in an individual specification, shall apply to the ASTM product specifications noted below.
|
Title of Specification |
ASTM |
|
Seamless Carbon-Molybdenum Alloy-Steel Boiler and |
A209/A209M |
|
Seamless Ferritic and Austenitic Alloy-Steel Boiler, Superheater, |
A213/A213M |
|
Welded Austenitic Steel Boiler, Superheater, Heat-Exchanger, |
A249/A249M |
|
Electric-Resistance-Welded Ferritic Alloy-Steel Boiler and |
A250/A250M |
|
Seamless and Welded Ferritic and Martensitic Stainless Steel |
A268/A268M |
|
Seamless and Welded Austenitic Stainless Steel Tubing for |
A269 |
|
Seamless and Welded Austenitic Stainless Steel Sanitary Tubing |
A270 |
|
Seamless and Welded Carbon and Alloy-Steel Tubes for |
A334/A334M |
|
Welded Austenitic Stainless Steel Feedwater Heater Tubes |
A688/A688M |
|
Austenitic Stainless Steel Tubing for Breeder Reactor Core |
A771/A771M |
|
Seamless and Welded Ferritic/Austenitic Stainless Steel Tubing |
A789/A789M |
|
Welded Ferritic Stainless Steel Feedwater Heater Tubes |
A803/A803M |
|
Austenitic and Ferritic Stainless Steel Duct Tubes for Breeder |
A826/A826M |
|
High-Frequency Induction Welded, Unannealed Austenitic Steel |
A851 |
1.2In the case of conflict between a requirement of a product specification and a requirement of this general requirements specification, the product specification shall prevail. In the case of conflict between a requirement of the product specification or a requirement of this general requirements specification and a more stringent requirement of the purchase order, the purchase order shall prevail.
1.3The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. The inch-pound units shall apply unless the “M” designation (SI) of the product specification is specified in the order.
Related products
